top of page

Finished Width: 54 inches

Roll Size: 40 yards

Weight: 32 +/- 2 oz per linear yard

Thickness: 44 +/- 3 mils

Abrasion resistance: No significant wear after 30,000 double rubs with #10 cotton duck using the Wyzenbeek test method

Cold Crack -25° F

1000 Hours WeatherOmeter

Mildew Resistant

Flame Resistance:


CA TB 117-2013 (Section 1-Cover Fabric)

NFPA 260

UFAC Class 1


Yorktown White

Yorktown Beechnut

Yorktown Pale Green

Yorktown Slate Grey

Yorktown Squash

Yorktown Bittersweet

Yorktown Indigo

Yorktown Ash

Yorktown Tan

Yorktown Chestnut

Yorktown Ox Blood

Care & Cleaning

To prevent build up of dirt and contaminates, which may cause permanent staining, periodic cleaning is highly suggested. The frequency of cleaning is dependent upon the environmental conditions the material is subjected to. For normal cleaning: Most stains can be easily cleaned using warm, soapy water and clear water rinses. Moderate scrubbing with a medium bristle brush will help loosen soiling materials from the depressions of embossed surfaces. For more stubborn stains, use Formula 409® commercially available cleaner in accordance with the manufacturer's instructions. Full strength rubbing alcohol or mineral spirits* may be tried cautiously as a last resort on very stubborn stain, if the above suggestions do not work. Indiscriminate use of any solvent, or solvent containing cleaner, can severely damage or discolor vinyl. Always follow with a clear water rinse after cleaning with solvents. Note: Detergents should never be used on a regular or repeated basis for normal cleaning. Morbern recommends repeated rinsing with clear water after any cleaning procedure. When opening a new container, please test the cleaner in an inconspicuous area as cleaning manufacturers may change formula without notice. Morbern cannot be responsible when unknown changes are made by the manufacturer of the cleaner to their formulations. *Caution: Exercise care as these solvents are flammable. Use only small quantities of solvents and keep clear of any sources of ignition. Wear protective gloves and ensure cleaning takes place in a well ventilated area.

bottom of page